Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
MT
• Do not allow processed mate-
rial to accumulate in the ejec-
tion zone since this can prevent
proper ejection and cause the
material to be brought back into
the machine via the in-feed ap-
erture.
• Avoid an abnormal work pos-
ture. Always maintain your bal-
ance to ensure secure footing
on slopes. Walk, do not run.
Operation:
• Do not switch on the device if it
is held upside down or is not in
operating position.
Avoid starting the device unin-
tentionally. Make sure that the
device is switched off before
you pick it up or carry it.
Having your finger on the switch
of the device while carrying it
can cause accidents.
• Never point the device at others,
and in particular, do not point
the air jet at the eyes and ears
during operation.
• Always ensure secure position-
ing, particularly on slopes, when
working. Always hold the device
tightly with both hands and only
work with a correctly adjusted
carrying strap.
• Do not stretch too far and do
not lose your balance.
• If you are tired or lacking in
concentration or have consumed
alcohol or tablets, do not work
with the device. Always have a
break on time. Work using com-
mon sense. Move slowly, do not
run.
28
• Prolonged use of the device
can lead to blood circulation
disorders in the hands caused
by vibration. You can however
extend your machine use time
by wearing appropriate gloves
or by taking regular breaks.
• Avoid operating the machine in
poor weather conditions, espe-
cially when there is a lightning
hazard. Only work in daylight
or where there is good artificial
illumination.
• Stop the machine and remove
the batteries from the device.
Ensure that all moving parts are
at a full standstill:
- when you are not using the
device or when you are
transporting or leaving it unat-
tended;
- before removing any obstruc-
tion or blocked channels,
- before checking, cleaning or
carrying out other work on
the machine.
- after contact with foreign bod-
ies or if abnormal vibration
occurs.
• Keep the power source free of
refuse or other accumulated
material to prevent it from be-
coming damaged and avoid a
potential fire.
• Do not tilt the machine while the
power source is running.
• Do not use the device in a
closed or poorly ventilated area.
• Do not use the device near flam-
mable liquids or gases. There is
a risk of fire or explosion if this
advice is not heeded.
• In the case of an accident or
malfunction during operation,
Werbung
