Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the device must be switched off
immediately and the batteries
removed. Read the "Trouble-
shooting" section to correct any
malfunctions or contact our Ser-
vice Centre.
• Walk at a steady pace, do not
run.
• Ensure you are standing securely
and do not lose your balance.
Avoid an abnormal work pos-
ture.
• When material is being taken in
by the machine, never stand on
a higher level than the base of
the machine.
• If the machine becomes
clogged, turn off the power
source and disconnect the ma-
chine from the mains supply or
remove the batteries before free-
ing any refuse.
• Never operate the machine with
defective protective equipment
or shields, or without safety
equipment.
• Do not transport the machine
while the power source is running.
• Ensure that you do not touch any
of the dangerous moving parts
before you have unplugged the
machine from the mains supply
or removed the batteries from
the machine, and that the dan-
gerous moving parts have come
to a complete standstill.
• In the case of an accident
or malfunction during op-
eration, the device must
be switched off imme-
diately. Injuries must be
properly treated or medi-
cal assistance sought. Read
the "Troubleshooting" section to
correct any malfunctions or con-
tact our Service Centre.
Maintenance and storage:
• Regularly check the functional-
ity and integrity of the device to
avoid danger to the operator.
• Replace worn or damaged parts
in the interests of safety. Only
use original replacement parts
and accessories.
• Do not try to repair the device
yourself, unless you have pro-
fessional training. All work not
mentioned in these instructions
may only be performed by au-
thorised service representatives
commissioned by us.
• Store the device in a dry place
and out of reach of children.
• Treat your device with care.
Clean the ventilation slits
regularly and follow the mainte-
nance instructions.
• Keep all inlets for the cooling air
free of debris.
• Do not use the device if the
switch cannot be turned on and
off. Damaged switches must be
replaced at a customer service
workshop. Do not overload your
device. Only work within the
power range indicated. Do not
use low-performance machines
for heavy work. Do not use the
device for purposes for which it
is not intended.
• If you stop the machine for main-
tenance, inspection, storage or
to change accessories, switch
off the power source, discon-
nect the machine from the mains
supply or remove the batteries,
GB
MT
29
Werbung
