Parkside PFSA 20-Li C3 Originalbetriebsanleitung Seite 8

High-speed battery charger PLG 20 C1*
INPUT
Rated voltage
Rated power
consumption
Fuse (internal)
OUTPUT
Rated voltage
Rated current
Charging time
Protection class
* BATTERY AND CHARGER ARE NOT INCLUDED
Noise and vibration data
Noise measurement value determined in accordance
with EN 60745. The A-rated noise level of the
power tool is typically as follows:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear ear muffs!
Total vibration value of the handle a
Uncertainty
Symbols on the appliance
Always wear safety goggles.
Always wear a mask.
NOTE
► The vibration emission value given in these
instructions has been measured in accord-
ance with a standardised test procedure and
can be used for comparison of the power
tool with another tool.
► The specified vibration emission value can
also be used to make an initial exposure
estimate.
PFSA 20-Li C3
230–240 V ∼, 50 Hz (AC)
65 W
T3.15A
3.15 A
21.5 V (DC)
2.4 A
approx. 60 min
II / (double insulation)
L = 72.1 dB (A)
pA
K = 3 dB
L = 83.1 dB (A)
WA
K = 3 dB
< 2.5 m/s
h
K = 1.5 m/s
WARNING!
► The vibration emission value may differ from
the stated value during actual use of the
power tool, depending on of the manner in
which the power tool is being used.
► Try to keep the vibration loads as low as
possible. Measures to reduce the vibration
load are, e.g. wearing gloves and limiting the
working time. Wherein all states of operation
must be included (e.g. times when the power
tool is switched off and times where the power
tool is switched on but running without load).
General power
tool safety warnings
WARNING!
► Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or seri-
ous injury.
Save all warnings and instructions for future
reference.
2
The term "power tool" in the warnings refers to
2
your mains-operated (corded) power tool or battery-
operated (cordless) power tool.
1. Work area safety
a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence of flam-
mable liquids, gases or dust. Power tools create
sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control.
GB │ IE │
3 ■