Lenze 8200 vector Montageanleitung Seite 27

How to mount the filter:
1. Drill two or four M6 fixing holes (/) in the mounting plate and mount the filter
using 2 or 4 screws and washers.
– Observe dimensions and mounting clearances (23).
2. Push the fixing rails onto the heatsink of the basic device.
3. Remove the upper screw  including lock washers  and washers . Unscrew the
lower screw  as far that it is still secure in the thread.
4. Mount the basic device onto the filter using the screws , lock washers  and
washers .
– Observe tightening torque.
Mounting variant
Fig. 5 Filter assembly
How to mount the filter:
1. Drill two M6 fixing holes in the mounting plate and mount the filter using 2 screws
and washers.
After this, the basic device can be mounted to the right of the filter ( documentation
for the basic device).
EDK82ZZ113 DE/EN/FR 2.1
Mechanical installation

Mounting steps
E82ZZ007
4
27