Remaining Hazards - Scheppach HS700GE Anleitung

• The Scheppach machine may only be used with
original accessories and original tools made by the
manufacturer.
• Any other use exceeds authorization. The manufac-
turer is not responsible for any damages resulting
from unauthorized use; risk is the sole responsibility
of the operator.Remaining hazards.
m Remaining hazards
The machine has been built using modern technology in
accordance with recognized safety rules. Some remaining
hazards, however, may still exist.
• The rotating saw blade can cause injuries to fingers
and hands if the work piece is incorrectly fed.
• Thrown work pieces can lead to injury if the work
piece is not properly secured or fed.
• Noise can be a health hazard. The permitted noise
level is exceeded when working. Be sure to wear per-
sonal protective gear such as ear protection.
• Defective saw blades can cause injuries. Regularly
inspect the structural integrity of saw blades.
• The operating instructions supplied with the special
accessories must be observed and carefully read
when Scheppach special accessories are used.
• Even when all safety measures are taken, some re-
maining hazards which are not yet evident may still
be present.
• Remaining hazards can be minimized by following
the instructions in "Safety Precautions", "Proper
Use" and in the entire operating manual.
Equipment, Fig. 1
1 Engine
2 Rocker
3 Saw blade cover,
interior
4 Saw blade cover,
exterior
5 Reverse starter
6 Ignition switch
7 Safety chain
8 Supporting foot
9 Mounting hole
10 Cross strut
11 Return spring
12 Handle
13 Rocker insert
14 Driving mechanism
15 Adjustment screw for
rocker extension
16 Belt tensioning
screws
17 Fuel tank
18 Protective plate
19 Rocker extension
20 Locking lever
21 Belt cover
22 Spark plug connector
19