HEIDENHAIN POSITIP 8000 Installationsanleitung Seite 24

NOTICE
Electrostatic discharge (ESD)!
This product contains electrostatic sensitive
components that can be destroyed by electrostatic
discharge (ESD).
It is essential to observe the safety precautions for
handling ESD-sensitive components
Never touch connector pins without ensuring proper
grounding
Wear a grounded ESD wristband when handling
product connections
NOTICE
Damage to the product due to incorrect wiring!
The incorrect wiring of inputs or outputs can cause
damage to the unit or to peripheral devices.
Comply with the pin layouts and specifications of
the product
Assign only pins or wires that will be used
Further information: "Specifications", Page 29
5.3 Product overview
The connections on the rear panel of the device are
protected by dust protection caps from contamination and
damage.
NOTICE
Contamination or damage may result if the dust
protection caps are missing!
If no dust protection caps are fitted to unused
connections, this may impair the proper functioning of
the contacts or destroy them.
Remove dust protection caps only when connecting
measuring devices or peripherals
If you remove a measuring device or peripheral, re-
attach the dust protection cap to the connection
The type of connections for encoders may
vary depending on the product version.
Rear panel without dust protection caps
Further information: "A", Page 4
Connections:
1 X102
: 37-pin D-sub connection for digital TTL interface
(8 inputs, 16 outputs)
2 X112
: 15-pin D-sub connection for touch probes
(e.g. HEIDENHAIN touch probe)
3 X1-X6
: 15-pin D-sub connections for encoder with inter-
faces of the type 1 V , 11μA
PP
Four inputs enabled by default, with option of enabling
another two inputs
26
or EnDat 2.2
PP
4 X32-X34
: USB 2.0 Hi-Speed connection (Type-A) for print-
er or USB mass storage device
5 Speaker
6 Functional ground connection as per IEC/EN 60204-1
7 X116
: RJ45 Ethernet connection for communication and
data exchange with downstream systems or PC
X117
: Not currently supported
11 X100
: Power switch and power connection
Additional connections on devices with ID 1089177-xx:
8 X106
: 15-pin D-sub connection for analog interface
(4 inputs, 4 outputs)
9 X104
: 9-pin D-sub connection for universal relay interface
(2x relay changeover contacts)
10 X105
: 37-pin D-sub connection for digital interface
(DC 24 V; 24 switching inputs, 8 switching outputs)
Left side panel
12 X31
(under protective cover): USB 2.0 Hi-Speed connection
(Type-A) for printer or USB mass storage device
5.4 Connecting encoders
For encoders with an EnDat 2.2 interface:
If the corresponding encoder input has
already been assigned to an axis in the device
settings, then the encoder is automatically
detected upon restart, and the settings are
adapted. Alternatively, you can assign the
encoder input after you have connected the
encoder.
the following pin layout
Further information: "1 V
PP
Page 193
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the product", Page 24
Connect the encoder cables tightly to the respective
connections
Further information: "Product overview", Page 26
If the cable connectors include mounting screws, do
not overtighten them
HEIDENHAIN | POSITIP 8000 | Installationsanleitung | 09/2018
, 11 µA , EnDat 2.2",
PP