HEIDENHAIN POSITIP 8000 Installationsanleitung Seite 22

4 Mounting
4.1 Overview
This chapter describes the mounting of the product. It
contains instructions about how to correctly mount the
product on stands or holders.
The following steps must be performed only
by qualified personnel.
Further information:
Page 21
4.2 Assembly of the product
General mounting information
The mount for the mounting variants is provided on the
rear panel. The connection is compatible with the VESA
standard 100 mm x 100 mm.
Further information: "H", Page 189
The material for attachment of the mounting variants on
the device is included in delivery.
You will also need the following:
Torx T20 screwdriver
Torx T25 screwdriver
Allen key, size 2.5 (Duo-Pos stand)
Material for mounting on supporting surface
The unit must be mounted to a stand or a
holder to ensure the correct and intended use
of the product.
4.2.1 Mounting on Single-Pos stand
You can fasten the Single-Pos stand to the product at a
20° angle.
Use the provided M4 x 8 ISO 14581 countersunk head
screws to fasten the stand to the upper VESA 100
threaded holes on the rear panel
Comply with the permissible tightening torque
of 2.6 Nm
Fasten the stand with two suitable screws from above
to a supporting surface
or
Attach self-adhesive rubber pads to the underside of
the stand
Route the cable from behind through the opening of
the stand and then through the lateral openings to the
connections
Further information: "B", Page 4
Dimensions of the Single-Pos stand
Further information: "I", Page 190
24
"Personnel qualification",
Mounting on Duo-Pos stand
You can fasten the Duo-Pos stand to the product at a 20°
or 45° angle.
Use the provided M4 x 8 ISO 7380 hexagon socket
screws to fasten the stand to the lower VESA 100
threaded holes on the rear panel
Comply with the permissible tightening torque
of 2.6 Nm
Using the mounting slots (width = 4.5 mm), screw the
stand to a supporting surface
or
Set up the device freely at the desired location
Route the cable from behind through the two supports
of the stand and then through the lateral openings to
the connections
Further information: "C", Page 4
Dimensions of the Duo-Pos stand
Further information: "J", Page 191
4.2.2 Mounting on Multi-Pos stand
Use the provided M4 x 8 ISO 14581 countersunk head
screws (black) to fasten the stand to the VESA 100
threaded holes on the rear panel
Comply with the permissible tightening torque
of 2.6 Nm
Using two M5 screws, you can also optionally screw
the stand to a supporting surface from the bottom
Adjust the desired angle of inclination within the tilting
range of 90°
To fix the stand: Tighten the T25 screw
Comply with the tightening torque for
screw T25
Recommended tightening torque:
5.0 Nm
Maximum permissible tightening
torque: 15.0 Nm
Route the cable from behind through the two supports
of the stand and then through the lateral openings to
the connections
Further information: "D", Page 4
Dimensions of the Multi-Pos stand
Further information: "K", Page 192
HEIDENHAIN | POSITIP 8000 | Installationsanleitung | 09/2018