HEIDENHAIN POSITIP 8000 Installationsanleitung Seite 25

5.5 Connecting touch probes
The following touch probes can be connected
to the unit:
HEIDENHAIN TS 248 touch probe
HEIDENHAIN KT 130 edge finder
Further information:
accessories", Page 22
Comply with the pin layout
Further information: "X112", Page 196
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the product", Page 24
Connect the touch probe firmly
Further information: "Product overview", Page 26
If the cable connectors include mounting screws, do
not overtighten them
HEIDENHAIN | POSITIP 8000 | Installationsanleitung | 09/2018
"Items supplied and
5.6 Wiring switching inputs and outputs
WARNING
Hazard when using switching inputs for safety
functions!
If switching inputs for mechanical limit switches are
used for safety functions, severe injury or death can
result.
Do not use the switching inputs for mechanical limit
switches for safety functions
Depending on the peripherals to be
connected, the connection work may need to
be carried out by an electrical specialist.
Example: Safety Extra Low Voltage (SELV)
exceeded
Further information:
Page 21
The product fulfills the requirements of
standard IEC 61010-1 only if the power to
the peripheral devices is supplied from a
secondary circuit with current limitation as per
IEC 61010-1 3rd Ed.
limitation as per IEC 60950-1
2.5 or from a Class 2 secondary circuit as
specified in UL1310.
In place of IEC 61010-1
corresponding sections of standards DIN EN
61010-1, EN 61010-1, UL 61010-1 and CAN/
CSA-C22.2 No. 61010-1can be used, and, in
place of IEC 60950-1
corresponding sections of standards DIN EN
60950-1, EN 60950-1, UL 60950-1, CAN/CSA-
C22.2 No. 60950-1 can be applied.
Wire switching inputs and outputs in accordance with
the pin layout
Further information: "X102", Page 194
Further information: "X104", Page 194
Further information: "X105", Page 195
Further information: "X106", Page 195
Further information: "X112", Page 196
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information: "Assembly of the product", Page 24
Connect the connecting cables of the peripherals
tightly to their connectors
Further information: "Product overview", Page 26
If the cable connectors include mounting screws, do
not overtighten them
The digital or analog inputs and outputs must
be assigned in the device settings of the
respective switching function.
"Personnel qualification",
, Section 9.4 or with power
2nd Ed. , Section
3rd Ed. , Section 9.4, the
2nd Ed. , Section 2.5, the
27