Orbea RISE HYDRO 2022 Schnellstartanleitung Seite 10

18 | OR B EA
OPERATION OF THE RANGE EXTENDER
The Range Extender powers the EP8 RS motor directly.
When using Rise with a Range Extender connected to the
system, the motor will only draw power from the Range
Extender until the Range Extender is depleted. When there
is no charge left in the Range Extender, the internal battery
will start powering the motor if it had any charge left.
BATTERY LEVEL VISUALIZATION
COMBINED BATTERY LEVEL
When a Range Extender is connected to Rise, the system
calculates the total capacity of both the Range Extend-
er and the internal battery (792 Wh) and the remaining
battery level information for the system will take into ac-
count the charge left on both batteries out of the total
792 Wh capacity.
The combined charge level will be visible trough the
Shimano juntion or display or the Orbea RS Toolbox data
field for compatible Garmin devices.
STANDALONE RANGE EXTENDER BATTERY LEVEL
Press once the Range Extender main button to know the
current charge level.
The LEDs will show the current charge level in 25% incre-
ments from right to left for 5 seconds.
QUICKSTART GUI DE
When the Range Extender is connected to the bicycle
and its charge is depleted, the system will show, by
means of the available methods (displays, junction or RS
Toolbox) the available charge in the internal battery only,
accounting for the capacity of the internal battery alone
and not the internal battery and the Range Extender sys-
tem total capacity.
RI SE · H YDRO 2022
CHARGING THE RANGE EXTENDER
1. To charge the Range Extender, plug the RS charger to
the mains outlet. With the Range Extender not being
connected to the charger, the LED on the charger´s
body will blink in blue.
2. Disconnect the Range Extender connection cable to the
bicycle charging port (in case it is connected) by turning
counterclockwise the cable safety tabs first and careful-
ly pulling from the cable.
3. Connect the charger to the Range Extender correctly
aligning the connector pins with those of the Range Ex-
tender´s charging port. The charger´s body LED will turn
blue for 2 seconds and then it will start fading in and
out cyclically until the battery is completely charged.
While the Range Extender is being charged, the charge
indicator LEDs will show the current battery level. The
blinking LED shows the range (in 25% increments) that
is currently being charged.
4. When the battery is fully charged, the charger´s body
LED will light in blue permanently. Disconnect the
charger from the charging port by carefully pulling from
the charger connector.
If the charger´s LED lights in red when con-
necting the charger to the outlet or during
the charging process, there is a charging
anomaly. Immediately disconnect the charg-
er and read the charger troubleshooting
method in the Rise H Bluepaper technical
manual. If the problem persists, contact an
authorized dealer.
ORB EA | 19
1
2
3
4
100%
EN