Change Of The Hinge Position - Pkm KG 241.4 A++ weiß Bedienungsanleitung

3
Location
1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-
protection.
3. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold. If this is not possible the following minimum
distances are required: appliance ↔ coal / paraffin stoves: 30 cm; appliance ↔
electric / gas stoves: 3 cm.
4. Fit the spacers ( if supplied) on the rear of the condenser positioned at the back
of the appliance.
5. 5 cm free space above the appliance are required as well as sufficient distance to
adjacent kitchen furniture for proper ventilation.
6. Check that the appliance and the power cord are not damaged.
7. Install the appliance in a dry and well-ventilated place.
8. Protect the appliance from direct sunlight.
9. The doors must open completely and without hindrance.
10. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
11. Connect the appliance to the mains properly.
12. The nameplate is situated inside the appliance or at the back.

Change of the hinge position

WARNING! Switch off and unplug the appliance before changing the hinge
position. RISK OF ELECTRIC SHOCK!
The change of the position must be carried out by at least two persons; otherwise
you may hurt yourself or damage the appliance.
Components in plastic bag:
(12) Hinge cover
(13) 1 mm washers
1. Remove the two screws (3) of the top hinge (4). Remove the top hinge (4).
2. Remove the door from the middle hinge pin (lift) and place it on a non-
scratching surface.
INSTALLATION
27
3