Beurer TL 35 Gebrauchsanweisung Seite 24

8. CLEANING AND MAINTENANCE
The device should be cleaned from time to time.
 IMPORTANT
• Ensure that no water gets inside the device!
The device must be switched off, disconnected from the mains and allowed to cool down each time
before cleaning.
• Do not clean the device in the dishwasher. Use a slightly damp cloth to clean the device.
• Do not use any abrasive cleaning products and never submerge the device in water. Do not touch the
device with wet hands when it is plugged in and do not allow water to spray on the device. Only operate
the device if it is completely dry.
Storage
If you are not going to use the device for an extended period of time, disconnect it and store it in a dry
place, out of the reach of children.
Follow the storage instructions provided in the "Technical specifications" chapter.
9. ACCESSORIES AND REPLACEMENT PARTS
To purchase accessories and replacement parts, please visit www.beurer.com or contact the corresponding
service address (according to the service address list) in your country. Accessories and replacement parts
are also available from retailers.
Designation
Stand
Mains adapter
10. WHAT IF THERE ARE PROBLEMS?
Problem Possible cause
Device does not Device is switched off.
light up
No power
No power
LEDs have reached the end of their
service life. LEDs faulty
11. DISPOSAL
For environmental reasons, do not dispose of the device in household waste at the end of its service life.
Dispose of the device at a suitable local collection or recycling point in your country. Observe the local
regulations for material disposal. Dispose of the device in accordance with EC Directive Waste
Electrical and Electronic Equipment (WEEE). If you have any questions, please contact the local
authorities responsible for waste disposal. You can obtain the location of collection points for old
devices from the local or municipal authorities, local waste disposal companies or your retailer, for
example.
Article number
110.034
110.035
Solution
Touch the ON / OFF / TIMER button
Connect the mains adapter correctly to a
suitable socket.
The mains adapter is faulty. Contact
Customer Services or your retailer
For repairs, please contact Customer
Services or an authorised retailer.
24
.
4