Beurer TL 35 Gebrauchsanweisung Seite 21

5. DEVICE DESCRIPTION
The associated drawings are shown on page 3.
Fluorescent screen
1
Colour temperature button
2
Timer display (in minutes)
3
ON / OFF / TIMER button
4
6. INITIAL USE
Take the device out of the plastic wrapping. Check the device for damage or faults. If you notice any
damage or faults on the device, do not use it and contact Customer Services or your supplier.
Setting up the device
Place the device on a level surface. The position should be chosen to ensure a distance of between 13 cm
and 35 cm between the user and the device. The lamp is most effective at this distance.
Mains adapter connector
• To prevent possible damage to the device, the daylight therapy lamp must only be used with the mains
adapter described here.
• Insert the mains adapter into the connector provided for this purpose on the rear of the daylight therapy
lamp. The mains adapter must only be connected to the mains voltage that is specified on the type
plate.
• After using the daylight therapy lamp, unplug the mains adapter from the mains socket first and then
disconnect it from the daylight therapy lamp.
 IMPORTANT
• Ensure that there is a mains socket close to the set-up area.
• Arrange the mains cable so that no-one will trip over it.
Brightness button (dimmer)
5
Stand
6
Mains adapter connector
7
21