ZAPTEC Pro Installationsanleitung Seite 8

3
Max 0.7 NM
Use the correct cable seal
EN
• Small cable seal:
• Large cable seal:
• Do not insert foreign objects
into the Type 2 socket.
• Do not insert test probes, wires or anything
else into the quick-release connector on the
back plate. Voltage tests should be performed
directly on the terminal screws or using a
female connector.
• The backplate connector is designed for
permanent connections and should not be
subject to a high number of mating cycles.
8
G H
10–16 mm.
16–18.5 mm.
G H
Dept. Technical reference Created by Approved by Dept. Technical reference Created by
Fredrik Ostrem
Fredrik Ostrem 01.08.2017
Document type
Document type Document status
Title
Title DWG No.
ZCS_Sealing_Cone_8mm_v1
Untitled
Rev. Date of issue Sheet
1/1
Bruk riktig kabeltetning
NO
• Liten kabeltetning: 10–16 mm.
• Stor kabeltetning: 16–18.5 mm.
• Ikke stikk fremmedlegemer inn i type
2-kontakten.
• Ikke sett testsonder, ledninger eller noe
annet inn i hurtigkontakten på koblingsplaten
(bakplaten). Spenningstester skal utføres
direkte på klemskruene eller ved hjelp av
en hunnkontakt.
• Bakplatekontakten er designet for permanente
tilkoblinger og bør ikke utsettes for et høyt
antall paringssykluser.
Approved by
01.08.2017
Document status
DWG No.
Rev. Date of issue Sheet
1/1
G H