Dometic FRESHWELL FWX4350EHP Montage- Und Betriebsanleitung Seite 27

3. Ensure that the pipes are connected to the register output (Components, 10).
4. To achieve the best efficiency follow these instructions:
a) Lay the air pipes as short and straight as possible.
b) Restrict the length of the pipes to 5 m.
c) Do not lay the pipes near heat sources.
5. Create the recirculation air opening (Fig. /Fig. ,2) near the under-bench air conditioner.
Note The recirculation air openings or grille must have a total cross section of at least 300 cm² to
draw in sufficient recirculation air.
If the installation of the recirculation air opening (Fig. /Fig. ,2) near the under-bench air conditioner is not
possible, ensure that the air flow is not obstructed by other objects. If necessary, create an air duct between the
openings and the under-bench air conditioner.
6. To avoid condensation on the pipes insulate the pipes with insulation material.
11 Before first use
Note
Ensure that both the air intake opening and the air nozzles are free. All ventilation grilles must always be
kept free to ensure that the under-bench air conditioner is able to operate at maximum capacity.
Setting the remote control
1. Insert the batteries (see
The display shows all symbols for 5 s.
2. Press simultaneously the
The display shows the default model number.
3. Press simultaneously
• FreshWell: 02
• FreshJet: 07
• FreshLight: 11
The display shows all symbols for 5 s. Afterwards the remote control is ready for operation.
Setting the time
Set the current time, see
12 Operation
NOTICE! Damage hazard
Do not use the under-bench air conditioner if the vehicle is tilted more than 10 °.
Replacing the remote control
and buttons during this 5 s.
+ –
and button within 3 s to select the model number:
Setting the time.
batteries).
EN
25