Product-Specific Safety Instructions - BWT AQA stop Einbau- Und Bedienungsanleitung

EN
1.7 Product-specific safety
instructions
No water for extinguishing fires!
Lethal hazard!
► This device may not be installed in
► Safety equipment (such as thermal
Electric shock!
Lethal hazard!
► Modifications to the mains connec-
► Any modification of the device voids
14
DANGER
systems that provide water for fire
extinguishing purposes.
discharge safety devices) as well
as any devices or system parts re-
quiring a permanent water supply
must be supplied from a separate
line that branches off upstream of
this device.
DANGER
tion cable (shortening or lengthen-
ing) are prohibited.
the warranty.
Notes on safe operation
► The effectiveness of the AQA stop
is restricted to the room in which the
sensor is located.
► The unit requires a constant power
supply. When the power supply
is interrupted (e.g. due to a power
outage), the device closes off the
water supply.
► The electronics housing must not
get wet. If the housing should in-
advertently get wet: Remove the
mains plug. Thoroughly dry off the
housing and let it air-dry. For safety
reasons, the housing must never be
opened.
In the following chapters, you will find product-
specific safety instructions whenever you must
perform certain safety-related actions on the device.
Note