Meec tools 011488 Bedienungsanleitung Seite 24

EN
STARTING/SWITCHING OFF
1. Start the product by pressing the power
switch.
FIG. 4
– The product starts at high speed.
2. Press the power switch again to switch off
the product.
See table for suitable speed for different jobs.
SANDING
WARNING!
Check that the sandpaper is not touching the
workpiece when starting the product – risk of
personal injury and/or material damage.
FIG. 5
• Never use the product without sandpaper,
this can damage the sanding pad.
• Do not force the product. Excessive
pressure produces inferior results and can
damage the sandpaper and/or reduce the
life span of the product.
• The sanding pad can be damaged if the
edge of the pad comes into contact with
the workpiece.
• Hold the product in a firm grip. Start the
product and wait until the motor has
reached full speed. Apply the sandpaper
carefully against the workpiece. Hold the
product with the sanding pad flush with
the workpiece and gently press the
product.
• The sanding pad rotates clockwise when
pressure is applied on the product, but
can rotate anticlockwise if the product is
run freely.
24
MAINTENANCE
IMPORTANT:
Switch off the eccentric sander and remove
the battery before checking, cleaning,
maintenance or adjustments, and before
changing accessories.
CLEANING
Clean the sander after use for best functionality
and life span. Use a soft cloth and a mild
detergent. Do not use petrol, solvents or
detergents that can damage the plastic parts.
REPAIRS
Repairs must only be carried out by an
authorised service centre or other qualified
personnel using identical spare parts.