Meec tools 011488 Bedienungsanleitung Seite 23

necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
Effective battery powered eccentric sander with
outlet for connection to vacuum cleaner. Dust
collector and 3 sandpapers included (80, 100,
120). The product is a part of the Meec Multi-
series – a series of power tools and garden
equipment that uses the same battery and
charger. Battery and charger sold separately in
Jula's department stores and at www.jula.com.
USE
BATTERY
About lithium-ion
Lithium-ion batteries have a safety system that
automatically switches off the product in the
following situations to prolong the battery life.
Overload
The product is used in such a way that there
is an abnormally high consumption of power.
If this happens, stop using the product in this
way. Press the power switch again to start the
product. If the product will not start this is
because the battery is overheated. Allow the
battery to cool and then press the power switch
again.
Low battery voltage
The battery is discharged and the product will
not start. Remove the battery from the product
and charge it.
Inserting/removing the battery
IMPORTANT:
• Switch off the eccentric sander before
inserting/removing the battery.
• Keep a firm grip on the eccentric sander
and the battery when inserting/
removing the battery. Otherwise there is
a risk of it slipping, with a risk of
material damage and/or personal injury.
1. Remove the battery by pressing the
release button (1) on the front of the
battery (2) and pulling the battery from
the product.
FIG. 1
2. To fit the battery, align the horns on the
battery to the slots in the casing and press
the battery in place. Press in the battery
all the way until it clicks into place.
FITTING/REPLACING ABRASIVE
PAPER
IMPORTANT:
Switch off the eccentric sander and remove
the battery before checking, cleaning,
maintenance or adjustments, and before
changing accessories.
Remove any dirt and foreign objects from the
sanding pad before fitting the sandpaper. Align
the holes in the sandpaper with the holes in
the sanding pad and press on the sandpaper.
FIG. 2
1. Sanding pad
2. Sandpaper
FITTING THE DUST COLLECTOR
Fit the dust collector (1) on the sander with the
opening turned down.
FIG. 3
IMPORTANT:
Only fit the dust shield at the given angle,
otherwise the product can be damaged.
EN
23