Herunterladen Inhalt Inhalt Diese Seite drucken

Trial Run; Plunge Cuts - Parkside Performance PSSAP 20-Li C3 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
˜ Trial run
NOTE
Always carry out a no-load trial run
u
before starting work and after every saw
blade replacement . Switch the product off
immediately if the saw blade is not running
smoothly, if considerable vibration occurs
or if you hear abnormal noises .
˜ Working instructions
m
CAUTION! RISK OF INJURY AND
DAMAGE TO PROPERTY!
Wear gloves when handling the saw blade .
u
In this way, you avoid injury from cuts .
Do not use any blunt or bent blades or
u
blades which are damaged in any other
way .
Before sawing the workpiece, check for
u
hidden foreign objects such as nails,
screws . These must be removed .
Always insert a suitable saw blade .
u
Secure the workpiece with the aid of
u
clamping devices on the workbench .
Apply only as much pressure as is required
u
for sawing . If there is excessive pressure,
the sawing blade may bend and break .
Switch the product off immediately if the
u
sawing blade jams .
Spread the saw cut out and pull the blade
out carefully .
38 GB/IE
m
CAUTION! RISK OF INJURY AND
DAMAGE TO PROPERTY!
Always stand to the side of the product
u
when working .
Always make sure that the workplace is
u
well ventilated .
Avoid over-stressing the product while
u
working .
Regular cuts
Verify the saw blade is not touching the
 
workpiece . Then, switch on the product .
Apply the base plate
 
Use even pressure, advancing at a steady
 
pace when making your cut . You can make
horizontal, diagonal, or vertical cuts .
When you are finished: First, switch off the
 
product . Then, pull the saw blade out of the
workpiece .

Plunge cuts

(Fig . J)
Plunge cuts are very challenging and are
 
associated with a higher risk of injuries . Only
use this technique if you are familiar with it .
Plunge cuts may only be carried out in soft
 
materials such as wood or plasterboard and
with short blades (max . length 150 mm) .
There is a risk of kickback and personal injury .
Place the front edge of the base plate
 
the workpiece so that the saw blade does not
touch the workpiece .
Turn the product on . Let the saw blade slowly
 
plunge into the workpiece .
When the workpiece depth has been cut
 
through, continue sawing as usual .
to the workpiece .
4 ]
[
on
4 ]
[

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis