Introduction; Device Description (Fig. 1 - 7); Scope Of Delivery; Proper Use - Parkside PVKO 50 B2 Originalbetriebsanleitung

2. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and suc-
cess.
Note:
In accordance with the applicable product liability laws, the
manufacturer of this device assumes no liability for damage to
the device or caused by the device arising from:
• Improper handling
• Failure to comply with the operating manual,
• Repairs carried out by third parties, unauthorised specialists
• Installing and replacing non-original spare parts,
• Improper use
• Failures of the electrical system in the event of the electrical
regulations and VDE provisions 0100, DIN 57113 / VDE
0113 not being observed
Note:
Read the whole text of the operating manual before assembly
and commissioning.
This operating manual should help you to familiarise yourself
with your device and to use it for its intended purpose.
The operating manual includes important instructions for safe,
proper and economic operation of the device, for avoiding
danger, for minimising repair costs and downtimes, and for
increasing the reliability and extending the service life of the
device.
In addition to the safety instructions in this operating manual,
you must also observe the regulations applicable to the opera-
tion of the device in your country.
Keep the operating manual at the device, in a plastic sleeve,
protected from dirt and moisture. They must be read and care-
fully observed by all operating personnel before starting the
work.
The device may only be used by personnel who have been
trained to use it and who have been instructed with respect to
the associated hazards.
The required minimum age must be observed.
In addition to the safety instructions in this operating manual
and the separate regulations of your country, the generally
recognised technical rules relating to the operation of such ma-
chines must also be observed.
We accept no liability for accidents or damage that occur due
to a failure to observe this manual and the safety instructions
16 GB

3. Device description (Fig. 1 - 7)

1. Transport handle
2. Quick-coupling (regulated compressed air)
3. Pressure vessel
4. Wheel
5. Drain screw for condensate
6. Foot
7. Safety valve
7.1. Drain nut
7.2. Safety connection
7.3. Cap
8. On/off switch
9. Manometer (regulated pressure)
10. Pressure regulator
11. Manometer (container pressure)
12. Wheel bolt
13. Spiral hose, 5 m
13.1 Connection
13.2 Quick-coupling (Spiral hose)
14. Compressed air tyre inflation meter
14.1 Inflation hose
14.2 Valve plug connection
14.3 pressure gauge
14.4 Scale
14.5 Connection
14.6 Trigger lever
15. Adapter set
A. Hexagonal bolt
B. Nut
C. Washer
D. Flange nut

4. Scope of delivery

• Compressor
• 2x wheels (4)
• 2x feet (6)
• Assembly material
• Operating manual
• Spiral hose, 5 m (13)
• Compressed air tyre inflation meter (14)
• Adapter set (15)

5. Proper use

The compressor is used to generate compressed air for pneu-
matically powered tools that can be operated with an air rate
of up to 140 l/min. (e.g. tyre inflaters, air blow guns, paint
spray guns). Due to the limited air flow rate, it is not possible
to operate tools with a very high compressed air consumption
(e.g. orbital sanders, straight grinders and impact screwdriver).
The machine may only be used in the intended manner. Any
use beyond this is improper. The user/operator, not the manu-
facturer, is responsible for damages or injuries of any type re-
sulting from this.