Elcometer PTG6 Bedienungsanleitung Seite 23

10 BATCHING - PTG8 (continued)
To create a new sequential batch:
1 Press Batch/New Batch/Batch Type.
é ê
2 Use the
'Select'.
To create a new grid batch:
1 Press Batch/New Batch/Batch Type.
é ê
2 Use the
é ê
3 Use the
press 'Select' to toggle between across columns (è) or down
rows ( ).
ê
é ê
4 Use the
'Select' then use the
required and press 'Ok'.
é ê
5 Use the
'Select' then use the
columns required and press 'Ok'.
The maximum number of columns available is dependent on the number
4
of rows selected and vice versa.
For example:
a) Increment Direction = Across,
Number Of Rows = 3,
Number Of Columns = 3.
The first reading will be saved in cell A1, the
second A2, the third A3, the fourth B1 and so
on.
b) Increment Direction = Down,
Number Of Rows = 3,
Number Of Columns = 3.
The first reading will be saved in cell A1, the
second B1, the third C1, the fourth A2 and
so on.
The batch settings are saved in the batch header
and can be viewed at any time via Batch/Review
Batch/Batch Information.
www.elcometer.com
sofkeys to highlight 'Sequential' and press
sofkeys to highlight 'Grid' and press 'Select'.
sofkeys to highlight 'Increment Direction' and
softkeys to highlight 'Number Of Rows', press
é ê
softkeys to enter the number of rows
softkeys to highlight 'Number Of Columns', press
é ê
softkeys to enter the number of
R
è
A1 A2 A3
B1 B2 B3
C1 C2 C3
ê
A1 A2 A3
B1 B2 B3
C1 C2 C3
22