Threading The Bobbin Thread - Singer C620L Bedienungs- Und Sicherheitshinweise

THREADING THE BOBBIN THREAD

1. Raise the needle to its highest position by rotating the hand wheel toward you.
2. Remove the bobbin cover plate by pushing the release button to the right. Bobbin cover
will pop up sufficiently to allow you to remove the cover.
3. Insert the bobbin making sure the bobbin rotates counter-clockwise when you pull the
thread.Træk tråden gennem rillen (A) og derefter til venstre.
NOTE: This is a very important step as the bobbin can become unthreaded and cause sewing
problems if it rotates clockwise.
4. Pull thread through the slot (A) and then to the left.
5. With a finger held gently on top of the bobbin, pull the thread until it stops in slot (B).
Then pull about 6" (15 cm) of thread and lead it towards back of the machine under the
presser foot.
NOTE: This is also a very important step to assure the bobbin thread does not slip out of
position.
6. Replace the bobbin cover plate onto the needle plate.
10 –EN