Unpacking; Attachment / Before Starting The Equipment - Scheppach BGT2800 Original Bedienungsanleitung

Noise & Vibration
Operating mode S1 (continuous opera-
tion)
The machine can be continuously operated
with the quoted power output.
Operating mode S2 (temporary opera-
tion)
The machine may be temporarily operated
with the quoted power o utput. Afterwards
the machine must be stopped for a while to
prevent it from overheating.
Noise
m WARNING: Noise can have serious ef-
fects on your health. If the machine noise
exceeds 85 dB (A), please wear suitable
hearing protection.
Information concerning noise emission
measured according to relevant standards:
Sound pressure L = 95,11 dB(A)
pA
Sound power L = 75,09 dB(A)
wA
Uncertainty K = 1,33 dB
pA

7. Unpacking

Open the packaging and remove the device
carefully.
Remove the packaging material as well
as the packaging and transport bracing (if
available). Check that the delivery is com-
plete. Check the device and accessory
parts for transport damage.
In case of complaints the dealer must be
informed immediately. Subsequent com-
plaints will not be accepted.
If possible, store the packaging until the
warranty period has expired.
Read the operating manual to make yourself
familiar with the device prior to using it.
Only use original parts for accessories as
well as for wearing and spare parts. Spare
parts are available from your specialized
dealer.
Specify our part numbers as well as the
type and year of construction of the device
in your orders.
m ATTENTION!
The device and packaging materials are
not toys! Children must not be allowed
to play with plastic bags, film and small
parts! There is a risk of swallowing and
suffocation!
8. Attachment / Before starting
the equipment
m IMPORTANT!
You must fully assemble the appliance be-
fore using it for the first time!
Your machine is not fully assembled
Assembling the transport device (Fig.
4/5/6)
1. Guide the wheel axle (H) through the
guide (a) until it latches.
2. Guide the wheel (13) onto the wheel ax-
le (H) and fasten to the wheel axle with
a washer (N) and spring washer (O) and
one hexagonal nut (J) respectively. (Fig.
4)
3. Mount the support foot (B) on the frame
strut at the bottom. Fasten the support
foot with two screws (F) and nuts (L)
(Fig. 5)
4. Mount the transport handles (4) on the
frame. Fasten the transport handles with
the screw (G) and nut (K); two plastic
washers (M) respectively are placed be-
tween the frame and fork of the transport
handle. (Fig. 6)
Attention! Fill the oil before first use.
Before each use, check the oil level with the
engine switched off and on a level surface.
Use the highest quality four-stroke oil or an
HD oil with the same level of quality.
Checking the oil level (Fig. 7)
Remove the oil filler cap (7) and wipe the
dipstick clean. Check the oil level by insert-
ing the dipstick into the filling nozzle without
screwing the cap on. If the oil level is too
low, refill with the recommended oil up to
the lower rim of the oil filling nozzle.
www.scheppach.com
GB | 25