EMAK KTK 102H Serie Gebrauchsanweisung Seite 147

PROBLEM
5. Starting is difficult or the
engine runs erratically
6. Weak engine
performance
during cutting
7. The engine stops
when the cutting
device are engaged
8. The battery indicator
light remains on even
after the machine
has been running
for a few minutes
9. The oil indicator light
switches on during
operation (if fitted)
10. The engine stops
running and an acoustic
signal is generated
11. The engine stops
running, and no
acoustic signal
is generated
12. The cutting device do
not engage or do not
stop promptly when
they are disengaged
13. Uneven mowing and
insufficient collection
(for rear collection
models only)
14. Uneven mowing (side
discharge models only)
If problems persist after having performed the above operations, contact your Dealer.
PROBABLE CAUSE
carburation problems
forward speed too high in
relation to cutting height
engage not enabled
insufficient battery charge
engine lubrication problems
The safety device of the electronic
circuit board has cut in due to:
over-voltage caused by
the charger regulator
battery not connected
correctly (poor contacts)
battery disconnected
engine problems
loose belt
problems with the electro-
magnetic clutch
cutting device assembly is
not parallel to the ground
inefficient cutting device
forward speed too high
compared to height of grass
collector chute is blocked
cutting device assembly is
not parallel to the ground
inefficient cutting device
clean or replace the air filter
empty the fuel tank and refill with fresh fuel
check and replace the fuel filter if necessary
reduce the forward speed and/or
raise the cutting height (par. 6.5.4)
check that all starting conditions
are met (par. 6.2.2)
contact your Dealer
Turn the key to the «STOP»
position immediately:
top-up the oil level (see 7.3.1)
replace the filter (if the problem
persists, contact your Dealer)
Turn the ignition key to «STOP» position
and identify the cause of the problem:
contact your Dealer
check the connections (see 3.4)
check the connections (see 3.4)
contact your Dealer
contact your Dealer
contact your Dealer
check the tyre pressure (par. 6.1.3)
reinstate the alignment of the cutting device
assembly in relation to the ground (par. 8.2.1)
contact your Dealer
reduce the forward speed and/or raise
the cutting device assembly (par. 6.5.4)
wait for the grass to dry
remove the grass catcher bag and
empty the chute (see 7.6.2)
check the tyre pressure (par. 6.1.3)
reinstate the alignment of the cutting device
assembly in relation to the ground (par. 8.2.1)
contact your Dealer
EN - 28
REMEDY