Training With The R5 Gps; Gps Fix; Training Process; Saving And Evaluating The Training - VDO Cyclecomputing R5 GPS Handbuch

Training with the R5 GPS

Every time you switch on the device, the R5 GPS starts in the training screen to enable you to start training as quickly as possible. To switch the device on,
press and hold the START button for 3 seconds.
The R5 GPS starts searching for GPS satellites immediately after being switched on.

GPS Fix

To enable the R5 GPS to be connected to GPS / GLONASS as quickly as possible, please follow these instructions:
Find a field that is as open as possible (no trees, houses, etc. that interfere with reception)

If possible, do not move until you have received the message GPS OK or the GPS icon no longer flashes

Synchronize the R5 GPS as regularly as possible with the SIGMA RIDE app so that the most current GPS data is always available on the device


Training process

If you want to use GPS, wait until the message GPS OK. Then press the START button once to start the training.
If no data recorded, the training is either in auto pause or stopped. In this case you can see the training status in the display (circle element).
If you have not yet started the training but are moving at more than 2.2 km / h, you will receive a recurring request to start the training.
Data is only recorded when it has been started.
At any time during the training you can change the training views for the current sport profile, use the SIGMA RIDE app and follow the instructions
in the chapter Setting training views.
If you would like to calibrate other settings during the training, such as auto pause, tones or the altitude, keep the START button pressed to access the quick menu.
If you want to end the training, press the START button once. You can now start the training again by pressing the START button, or you can leave the training and save the
training session. To do this, hold down the "+" key.

Saving and evaluating the training

The training data is synchronized with the SIGMA RIDE app after the training.
You also have the option of synchronizing the data with the SIGMA RIDE app in third-party portals. Instructions for this can be found in the
data with third-party software.
On the device you will also find an overview of the total values performed.
To do this, open the main menu and select the area Storage > Totals.
chapter Synchronizing training