Site Preparation; Opening Dimensions; Electrical - Subzero ICBIC-18FI Installationsanleitung

SITE PREPARATION

Opening Dimensions

INTEGRATED MODELS
TOP VIEW
635 mm
OPENING
DEPTH
B A
635 mm
OPENING DEPTH OPENING OPENING WIDTH
HEIGHT
SIDE VIEW FRONT VIEW
OPENING DIMENSIONS A
COLUMN MODELS WIDTH
ICBIC-18FI 457 mm 2134 mm
ICBIC-24R, ICBIC-24FI 610 mm 2134 mm
ICBIC-30RID, ICBIC-30FI 762 mm 2134 mm
ICBIC-36RID 914 mm 2134 mm
TALL MODELS A
ICBIT-30RID, ICBIT-30CIID 762 mm 2134 mm
ICBIT-36CIID 914 mm 2134 mm
DRAWER MODELS A
ICBID-30RP, ICBID-30CI 762 mm
ICBID-36CI 914 mm
The depth of each integrated model is 610 mm. Allow for
panel thickness when planning the finished opening depth.

Electrical

Installation must comply with all applicable electrical codes.
The electrical supply must be located within the shaded
B
area shown in the illustration and chart below. A separate
HEIGHT
circuit, servicing only this appliance is required. A ground
fault circuit interrupter (GFCI) is not recommended and may
cause interruption of operation.
This appliance is equipped with an appliance inlet type
B
device. The appliance inlet is located at the bottom rear of
the appliance. When replacing the power cord verify the
replacement cord is rated HO5VV-F3G1.0 or equivalent to
B
ensure safe operation.
876 mm
876 mm
CAUTION
The outlet must be checked by a qualified electrician to
be sure that it is wired with the correct polarity. Verify
that the outlet is properly grounded (earthed).
WARNING
Do not use an extension cord, two-prong adapter or
remove the power cord ground prong.
ELECTRICAL REQUIREMENTS
Power Supply
Circuit Breaker
Receptacle
ELECTRICAL SUPPLY LOCATION
WIDTH
457 mm Models
610 mm Models
762 mm Models
914 mm Models
LEFT SIDE
OF OPENING
114 mm
A
108
E
mm
FLOOR
6 mm
FRONT VIEW
Electrical supply location.
Electrical
Shock
Hazard
Plug power cord directly into a properly
grounded (earthed) outlet.
Do not defeat the grounding (earthing)
nature of the plug.
Do not use adapter or extension cord.
Failure to follow these instructions could
cause serious injury or death.
See installation instructions
220-240 V AC, 50/60 Hz
10 amp
grounding-type (earthed)
A
152 mm
241 mm
318 mm
394 mm
|
subzero.com 3