SEB BeerTender VB31 Bedienungsanleitung Seite 37

Green beer-temperature LED on the right side of the panel: when the
Beertender Keg has reached the ideal temperature the LED switches on
®
and the appliance goes into "stand-by" cooling mode - fig. 19.
Sound emitted by the Beertender
• The cooling function of the Beertender
• The Beertender
temperature of the Beertender
1. stand-by cooling corresponds to the main operating conditions. In
this mode the cooling fan produces a barely audible noise;
2. active cooling is triggered when temperature inside the cooling
chamber is too high. Once the beer keg reaches the target temperature,
the beer pump shifts into standby cooling mode.
DISPENSING BEER
Note: always check the "best before end" date shown on the bottom of
the Beertender
®
Note: the beer must be dispensed into suitable containers; the dispensing
function is started and stopped manually by the user.
Step 1 – Preparing a glass
• To pour a perfect glass of beer, it is essential to use a clean, fresh glass.
Rinse the glass in cold water before dispensing beer (the colder the glass
the better) - fig. 20.
Tip: we recommend that you use your beer glasses for drinking beer
alone. Some beverages, like milk, leave a small residue in the glass which
will reduce the head on your beer.
Step 2 – Dispensing beer
Tip: Look at the control panel to check that the beer has reached
the right drinking temperature.
• Position a glass beneath the tap, holding it at an angle of 45 degrees
(see picture) - fig. 21.
features a cooling system which controls the
®
®
Keg. Do not use the Beertender
appliance
®
produces sound.
®
Keg. There are two cooling modes:
Keg beyond this date.
®
EN
37