Control Panel - SEB BeerTender VB31 Bedienungsanleitung

USING THE BEERTENDER
Inserting a Beertender
• Note: the Beertender
"Compatible Beertender
• The appliance can only be used if it contains a Beertender
only if the main switch is set to "I".
• The LED on the left side of the control panel, when illuminated, tells you
that the appliance is switched on.
• You can open the appliance by pressing the handle on top of the lid.
When the handle is released, you can lift the lid up - fig. 11-12.
Note: do not force the lid beyond the set opening position as this could
damage it.
• When the lid is completely open, insert a Beertender
the figure - fig. 13.
• Remove the upper part of the dispensing head (6) by lifting it upwards
as indicated in the illustration - fig. 14.
Note: this cover can be removed for cleaning.
• Install the Beertender
Note: Do not try to actuate the tap of the Beertender
• Position the beer tube as shown on drawing - fig. 15.
• Return the upper part of the dispensing head in its initial position.
Note: The upper part of the dispensing head cannot be repositioned
(fig. 16) if the Beertender
• Ensure that the upper part of the dispensing head is positioned in the
beer pump mechanism before closing the lid.
• Ensure that the positioning of the upper part of the dispensing head
conforms to the one in the illustration so as not to damage the beer
pipe - fig. 16.
• Gently close the appliance lid again until it lock - fig. 17.

Control panel

• Two LEDs on the top of the lid provide important indications:
• Green ON LED on the left of the panel: when lit, it indicates that the
appliance is operating - fig. 18.
36
SYSTEM
®
Keg
®
may only be used with Beertender
®
" containing beer sold by the Heineken group.
®
keg tap.
®
keg tap has not been properly set up.
®
Kegs
®
Keg and
®
Keg as shown in
®
Keg by hand.
®