Connecting To The Power Supply - SEB BeerTender VB31 Bedienungsanleitung

• Set the drip tray and grate in place at the front of the appliance. Make
sure the drip tray is properly fitted and positioned.
• Do not install the appliance near sources of heat or in places exposed
to direct sunlight.
Note: keep in mind that during use the drip tray will have to be
emptied and rinsed regularly. When the Beertender
in use, you can remove the drip tray and place it elsewhere to save
space.
Note: The drip tray must be positioned on a level surface and must
not jut out from the surface it is resting on.
• After installing the Beertender
spout; this is the only part of the appliance that will come into contact
with the beer - fig. 8.
• It is essential that you wash the dispensing spout before using
the appliance for the first time and at least every time a new keg is
connected inside the Beertender
- fig. 9.
• To clean the spout, remove it from its housing by turning it clockwise.
After washing the spout, screw it back into place - fig. 8.

Connecting to the power supply

Electricity can be dangerous! Therefore you must always
scrupulously abide by the safety rules.
• The appliance must be plugged into a suitable, properly installed electric
socket.
• The voltage of the appliance has been set in the factory. Check that the
mains voltage matches the voltage indicated on the rating plate on the
rear of the appliance.
• Make sure the main switch on the rear of the machine is set to "0"
before connecting the Beertender
socket with the correct voltage and turn on the appliance by moving the
main switch to "I" - fig. 10.
The appliance will immediately start cooling the inner chamber as soon
as the main switch is set to "I".
appliance you must clean the dispensing
®
system. The nozzle is dishwasher-safe
®
to the mains. Insert the plug into a
®
system is not
®
EN
35