Cutting Hairlines And Beard - Silvercrest 278224 Bedienungsanleitung

• Switch off the device after shaving, clean the parts carefully
(Chapter "Cleaning and care" on page 96) and to protect
the shaving heads 4, slide the protective cap 15 onto the
shaving attachment 5 from below.

6.6 Cutting hairlines and beard

WARNING! Risk of injury!
The points of the beard trimmer attachment 3 are sharp.
Handle with care.
• Figure C: adjust the cutting length at the comb attach-
ment 1 according to the desired hair length. Read the cut-
ting length on the side of the comb attachment 1 at the
marking 2. The arrow symbol
length is set. Now, shorten your beard step-by-step.
NOTE: ensure that the comb attachment 1 is still firmly attached
to the device after adjustment.
• Use the device only with the beard trimmer attachment 3
and without comb attachment 1, to cut beard and hairline.
In this way you can cut hair lengths of 1-2 mm evenly.
16 indicates which cutting
95
GB