Silvercrest 278224 Bedienungsanleitung Seite 90

If the device is used in a bathroom, the power unit must be
pulled out after use, as the proximity of water represents a
hazard, even when the device is switched off.
Installation of a residual current device (FI/RCD) with a rat-
ed residual operating current of no more than 30 mA is rec-
ommended to provide additional protection. Ask your
electrician for advice. The installation should only be carried
out by a qualified electrician.
DANGER! Risk of electric shock
Never put the device into operation if there are visible dam-
ages to the device, the power unit or the cable or if the de-
vice has been dropped before.
Connect the cable to the device before plugging the power
unit into a wall socket.
Only connect the power unit to a properly installed, easily ac-
cessible wall socket, the voltage of which corresponds to the
specifications on the rating plate. The wall socket must contin-
ue to be easily accessible after the device is plugged in.
Ensure that the cable cannot be damaged by sharp edges or
hot surfaces.
Ensure that the cable is not trapped or crushed.
When removing the power unit from the wall socket, always
pull the power unit and never the cable.
Pull the power unit out of the wall socket, ...
... after every use,
... after each charging process,
... if there is a fault,
... before connecting the device to the cable,
... before you clean the device and
... during thunderstorms.
88
GB