Removing And Cleaning The Shaving Head; Dismantling The Shaving Head - Silvercrest SBT 1.5 A1 - IAN 282641 Bedienungsanleitung

NOTE
► If...
– the shaving result deteriorates noticeably,
– the shave takes much longer than usual,
– there is any visible damage on the shaving head
... the shaving head
► You can order replacement shaving heads
department (see section "Ordering replacement parts").

Removing and cleaning the shaving head

To clean the shaving head
shaving head
1) Remove the protective cap
2) Turn the shaving head
until the marking on the shaving head
marking on the housing.
3) Pull the shaving head
Clean the shaving head
brush
water.
4) Dry off the shaving head
5) Also remove any remaining hairs using the cleaning brush
6) Replace the shaving head
ing head
on the shaving head
7) Replace the protective cap

Dismantling the shaving head

You can also dismantle the shaving head
particularly thoroughly:
│ GB │ IE
■ 28
needs to be replaced.
thoroughly, you need to remove the
from the housing:
in the opposite direction to the arrow
off the housing.
and/or rinse the shaving head
thoroughly if necessary.
in the direction of the arrow
points to the
(if fitted) from the housing.
using the supplied cleaning
on the housing and turn the shav-
marking on the housing.
on the housing.
if you want to clean it
,
from our service
points to the O
under running
.
until the marking
SBT 1.5 A1