Troubleshooting; Safety Notices; Troubleshooting Table - CASO DESIGN VRH 790 advanced Pro Original Bedienungsanleitung


Cleaning bags for reuse
Wash the bags in warm water with a mild dishwashing soap, then rinse them well and
allow them to dry completely before reusing.
ATTENTION

Bags used to store raw meats, fi sh or greasy foods should never be reused due to risk
of contamination.

Sealing profi le (6)
Remove the sealing profi le and clean it in warm soapy water.
PLEASE NOTE

The sealing profi le should be cleaned thoroughly before installing it again.

Make sure the seal is placed correctly so that the device can function properly.

8 Troubleshooting

The following table may help you narrow down and address minor malfunctions.

8.1 Safety notices

ATTENTION

Only qualifi ed electricians, who have been trained by the manufacturer may carry out
any repairs on electrical equipment.

Improperly performed repairs may result in personal injury or damage to the device.

8.2 Troubleshooting table

Die nachfolgende Tabelle hilft bei der Lokalisierung und Behebung kleinerer Störungen.
Error
Vacuum unit is not
functioning
The fi rst weld on the cut
off piece of the roll is not
being carried out
A complete vacuum is
not being created in the
bag
Possible cause
Power plug is not plugged in
Defective power cable or plug
Defective electrical socket
Roll is not positioned correctly
The open end of the bag is not
completely inside the vacuum
chamber
The bag is defective
There is dirt on the welding
and the normal seals
Rectifi cation
Plug in mains plug!
Contact Customer Service
Select another electrical socket
Follow the steps in the chapter
"making a bag using the bag roll"
Position the bag correctly
Select another bag
Clean the seals and retry correct-
ly once they are dry
CASO VRH 790 advanced Pro
DE
EN
FR
IT
ES
NL
PT
SE
37