Setting The Measurement Range - VOLTCRAFT 1897504 Bedienungsanleitung

e) Setting the measurement range
Set the measurement range to expand the scope of application of the camera.
There are two ranges:
High Gain
The camera reduces the measurement range to the most commonly used
temperature range and thus increases the detail display. This range is used to
display precise temperature differences.
Low Gain
The camera enables measurement operation over the whole measurement
range. In this case, however, the detail display is reduced. This range can be
used for rough overview measurements.
Auto
The camera automatically sets the respective mode to be displayed.
To set the measurement range, proceed as follows:
• Press the "SET" button to open the settings menu.
• Use the cursor buttons to select the "G" symbol and press the "SET" button to confirm the selection.
• Use the cursor buttons to select the corresponding parameters. The selected range will be highlighted in colour.
• Press the "SET" button to confirm the selection. The setting is marked with a yellow dot.
• To exit the menu, press the "Back" button.
37