Safety Instructions - VOLTCRAFT 1897504 Bedienungsanleitung

5. Safety instructions

These instructions contain important information on how to use the thermal imaging camera cor-
rectly. Please read them carefully before using the thermal imaging camera for the first time.
Damage caused due to failure to observe these instructions will void the warranty. We shall not
be liable for any consequential damage. We shall not be liable for damage to property or personal
injury caused by incorrect handling or failure to observe the safety information! Such cases will
void the warranty/guarantee.
• This device was shipped in a safe condition.
• To ensure safe operation and to avoid damaging the device, always observe the safety information and
warnings in these instructions.
• The unauthorized conversion and/or modification of the device is not permitted for safety and certification
reasons.
• Consult an expert when in doubt about the operation, safety or connection of the device
• Measuring instruments and their accessories are not toys and must be kept out of the reach of children.
• Always comply with the accident prevention regulations for electrical equipment when using the product
in commercial facilities.
• In schools, educational facilities, hobby and DIY workshops, measuring instruments must be used under
the responsible supervision of qualified personnel. The same applies when the measuring instrument is
used by people with reduced physical and mental capabilities.
• Do not use in the immediate vicinity of strong magnetic or electromagnetic fields, transmitter aerials or
RF generators. These may distort the measurements.
• If you suspect that safe operation is no longer possible, stop using the device immediately and prevent
unauthorized use. Safe operation can no longer be assumed if:
- There are signs of damage
- The device does not function properly
- The device was stored under unfavourable conditions for a long period of time
- The device was subjected to rough handling during transport.
• Do not switch the device on immediately after it has been brought from a cold room into a warm one. The
condensation generated may destroy the product. Leave the device switched off and allow it to reach
room temperature.
• Do not leave packaging material lying around carelessly, as it may become a dangerous toy for children.
• Store the device in a safe place where it cannot fall down! Otherwise, this could cause injuries.
• Never place the measuring instrument on a flammable surface (e.g. carpet) during charging. Always use
a suitable, non-flammable, heatproof surface.
• Ensure adequate ventilation during charging. Never cover the measuring instrument during charging.
• Never charge defective or damaged rechargeable batteries.
27