Connecting The Cooler - Dometic CFF18 Bedienungsanleitung

Operation
• Defrost the cooler once a layer of ice forms.
• Avoid unnecessarily low temperatures.
5.3

Connecting the cooler

Connecting to a battery (vehicle or boat)
The cooler can be operated with 12 V or 24 V
A
NOTICE! Damage hazard
Disconnect the cooler and other consumer units from the battery before
you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
For safety reasons the cooler is equipped with an electronic system to prevent
polarity reversal. This protects the cooler against short-circuiting when connecting to
a battery.
Using the fused DC plug
A
NOTICE! Damage hazard
For protection of the device the DC cable supplied includes a fuse inside
the plug. Do not remove the fused DC plug.
Only use the DC cable supplied.
1. Plug the DC connection cable (fig. 1 2, page 3) into the DC voltage socket of
the cooler (fig. 4 4, page 5).
2. Connect the connection cable to a DC power outlet.
Connecting to an AC power supply
D
DANGER! Electrocution hazard
Failure to obey these warnings will result in death or serious injury.
• Never handle plugs and switches with wet hands or if you are stand-
ing on a wet surface.
• If you are operating your cooler on board a boat from a AC power
supply, you must install a residual current circuit breaker between the
AC power supply and the cooler.
Seek advice from a trained technician.
22
CFF12, CFF18, CFF20, CFF35, CFF45, CFF70DZ
g
.
EN