CFX3
7.4
Connecting the cooler
A
NOTICE! Damage hazard
• For protection of the device the DC cable supplied includes a fuse
inside the plug. Do not remove the fused DC plug.
Only use the DC cable supplied.
• Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
Connecting to a battery
➤ Proceed as shown (fig. 7, page 7).
Connecting via extended DC hard-wiring (only CFX3 100)
➤ Proceed as shown (fig. 8, page 8).
Connecting to an AC power supply
D
DANGER! Electrocution hazard
• Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
• If you are operating your cooler on board a boat from a AC power
supply, you must install a residual current circuit breaker between the
AC power supply and the cooler.
Seek advice from a trained technician.
➤ Proceed as shown (fig. 9, page 9).
7.5
Using the cooler
A
NOTICE! Risk of overheating
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
I
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low.
EN
Operation
27