Connecting External Calls To Another Handset; Setting Up Conference Calls; Turning The Handset On And Off; Range Indications - AUDIOLINE DECT5500+ Bedienungsanleitung

3.7 Connecting external calls to another handset

If you have taken an external call on one handset, you can connect the call to another
handset. To do so, press the
called. Once the internal call is taken on the other handset, you have the following
possibilities:
A. Three way calling: you can now speak with the internal caller and use the
button to switch back to the external caller. You can switch between the internal and
external connections as often as you wish.
B. Forward the call: By pressing the call button,
be forwarded to the second handset.
3.8

Setting up conference calls

You can connect a second internal handset with an external call to set up a three-way
conference. To connect two handsets with an external call:
set up the desired connection with the external caller. Then press the
by the number of the handset being called. Once the second internal caller has answered,
press the # button for 2 seconds and all three callers will be connected in a conference
call.
3.9

Turning the handset on and off

By holding down the "R" button,
turned off, there is no drain on the battery. You cannot make or take calls.
Press the "R" button,
displayed and the handset will be ready for use after a brief delay.

3.10 Range indications

The range of the handset is about 50 metres in enclosed areas and about 300 metres in
the open. If a good connection to the base station is available, a
the display.
If you move too far from the base station, the
warning peeps. In this case you should move closer to the base station to avoid loosing
the connection.
36
- Normal use -
button and then the number of the handset being
,
you can turn off the handset. If the handset is
, briefly to turn the unit back on. The message, BASE, will be
, on the first handset, the call can
symbol will blink and you will hear
button followed
symbol will appear in