Making Calls; Handsfree Facility; Length Of Call Display; Internal Calls - AUDIOLINE DECT5500+ Bedienungsanleitung

3.3

Making calls

1. Use the key pad to enter the desired telephone number. Up to 25 digits may be
entered. The digits pressed will be shown in the display. Since the display can only
show 12 digits, only the last 12 of long phone numbers will be shown.
Notice: If you make a mistake you can briefly press the
at a time. If the
2. Press the call button,
Notice: You can also press the call button,
you enter the digits of the desired number, your AUDIOLINE DECT5501+ will send them
straight out. The correction of individual digits as described above is not possible in this
case.
3.4

Handsfree facility

Press the button at the start of or during a call. You will now hear the dialling tone
or the person you are speaking to over the loudspeaker in the handset.
By pressing the handsfree button
and handsfree mode during a call.
Always end calls made using the handsfree facility by pressing the call button
3.5

Length of call display

During a call, the duration of the call is displayed in minutes and seconds. 15 seconds
after dialling, the display changes from the number called to the length of call. The
length of call display persists for a few seconds after ending the call.
3.6

Internal calls

Once you have a number of handsets on a base station, you can make internal calls.
To do so, press the
handset called, the call is taken by pressing the call button,
- Normal use -
C / button is held down, the entire number will be deleted.
,
on the handset to place the call.
button and then the number of the handset being called. On the
,
first; you will then hear the dial tone. As
repeatedly you can change over between normal
C / button to delete one digit
.
.
35