Keep Warm Function; Memory Function; Display And Sounds - Gastroback 42445 Bedienungsanleitung

KEEP WARM FUNCTION

After heating, with the keep warm function activated, the appliance will switch to the
keep warm function automatically, keeping the set temperature for up to 30 minutes.
While the keep warm function is running, the ON/OFF button will be illuminated
in yellow. After 30 minutes in keep warm the heating elements will be deactivated
completely and the ON/OFF button will get dark (standby mode).
By simply pressing the KEEP WARM button, the keep warm function may be activated
or deactivated even while a heating cycle is running.
NOTE
When you have set a temperature above 90°C the keep warm function will always
fall back to 90°C. This is because the water within the kettle will be vaporized too
quickly, when boiling for a long period of time, leading to a lot of steam escaping
from the appliance. Additionally, the water level could go down below the MIN
filling level, thus causing the risk of overheating and high loss of energy. In fact:
The higher the set temperature, the higher the energy consumption for keeping
warm will be.

MEMORY FUNCTION

The appliance will keep the recently set temperature in memory, even after switching
off and disconnecting the appliance from the power supply.
IMPORTANT - To save any set temperature in memory, you need to start a heating
cycle. Thereafter, you may cancel the heating cycle immediately. Nevertheless,,
the set temperature will be kept in memory.

DISPLAY AND SOUNDS

When connecting the appliance to the power supply, a signal sounds and the actu-
al water temperature in the kettle will be shown on the display. However, with the
water temperature below 30°C, two dashes will be shown. After pressing the ON/
OFF button, the appliance will start heating immediately up to the set temperature.
During a heating cycle, the ON/OFF button is illuminated in red. As soon as the set
temperature is reached, several beeps sound and, with the keep warm function acti-
vated, the ON/OFF button changes to yellow indicating the keep warm function.
After another 30 minutes the ON/OFF button will get dark indicating the standby
mode. An additional acoustic signal sounds. However, the actual water temperature
will still be shown on the display.
When pressing the temperature selection button shortly with a heating cycle run-
EN
37