SOLIS VAC PREMIUM Bedienungsanleitung Seite 99

I . SE A L I NG A BA G F RO M
V A C UU M FI L M
1. Cut a suitable bag length from the film.
(see Fig. 1)
2. Open the appliance cover
and right release button in the case the appliance
cover is locked shut.
3. Place the open bag end on the sealing bar
open appliance. The bag end should not extend into
the vacuum chamber
(see Fig. 2)
4. Close the cover and push down on the two front
corners of the appliance cover until you hear a
„Click" from both sides. The cover is now locked
on both sides.
(see Fig. 3)
CAUTION: Never press the release buttons to close
the cover. Their only purpose is opening the cover.
5. Press the Seal (D) button in order to seal the end
of the bag. The green indicator light flashes several
times and goes out again when the sealing process
is finished.
(see Fig. 4)
6. Once the green indicator light goes out, pull up both
release buttons to open the cover.
(see Fig. 5)
7. Remove the bag with the sealed end.
8. Check if the seal seam is straight and without
creases. Should this not be the case, cut the seal
seam off and repeat the process.
≠
by pulling up the left
µ
¥
.
of the
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
99