SOLIS VAC PREMIUM Bedienungsanleitung Seite 115

P R OBLE MS A N D PO S SIBL E CAUS ES
s
TH E A P P LI AN CE D O E S N 'T WO RK
1. Check that the plug is plugged into the correct socket.
2. Check whether the power cable is damaged. If this is the case, bring the appli-
ance to Solis or a Solis approved service centre to get the cable replaced.
3. Check whether the socket is working by connecting another electrical device.
4. Check that the end of the bag is correctly in the vacuum chamber.
5. The vacuum sealer switches off automatically if it overheats. Let it cool down
first before starting to use it again.
T HE A P P L IAN CE I S N O T SE A L IN G AN EM PT Y BAG
Check that the end of the bag is lying correctly on the sealing bar, as is described
in section I. (Page 99).
T HE A I R I S N O T CO MPL ET E L Y SU C KED OU T OF T H E BAG
1. So that the bag gets completely sealed, the open end of the bag must lie com-
pletely in the vacuum chamber without any wrinkles.
2. Check that the sealing bar and the seals around the vacuum chamber are free
from dirt and in the correct position. Also, the seals must not be broken or
porous. Clean the seals and the sealing bar.
3. Check whether the bag has a hole in it. To do this, seal the bag with some air
in it and submerge it in water. If bubbles rise from it, it is leaking, use another
bag.
4. Use bags and films from Solis exclusively!
5. Perhaps the bag is not completely sealed, because of crumbs, fat or liquid in the
seal or the bag was not flat and has wrinkles or creases. Open the bag, clean
the inside of the bag end, the sealing bar and the rubber contact strip and make
sure to place the bag end absolutely evenly in the vacuum chamber.
6. Check if the cover is firmly shut on the left and right side.
115