Instructions For Measuring Without A Mobile Device - Megasat HD 1 Smart Bedienungsanleitung

3. Instructions for measuring without a mobile device

1. Connect „LNB" on the measuring device to the connection of the LNB of the satellite
system.
2. Connect „Receiver" on the measuring device to the coaxial cable leading to your satel-
lite set-top box and then switch it on. Alternatively, a suitable power supply or other
external power source (such as power bank) can be used via the USB port.
3. Turn on the meter at the power switch. All LEDs light up briefly and then display the
currently set parameters. Note: If the meter restarts again and again, check the con-
nection for a short circuit or the power consumption of the LNB is too high. If the
power consumption is too high, connect the LNB after the meter has started to re-
duce the starting load. Alternatively, connect the meter to a receiver or power supply
as the power source.
4. Use the SAT +/- buttons to select the desired satellite (eg Astra1 19.2° East).
5. If necessary, you can change the transponder. Usually you start with TP1.
6. Adjust the elevation required for your area and turn the system slowly, step by step,
until the „LOCK" LED lights up. Now use the TP +/- button to check further transpon-
ders of the satellite, if they are also displayed with the indication „LOCK" to exclude a
reflection or a wrong satellite.
7. When you have found the right satellite, you will do the fine tuning. Carefully move
the dish left, right, up, down until you reach the highest value on the 12-digit LED
display. Tighten the fixing screws of the dish evenly.
8. If necessary, you can use the app on the mobile device to get more information and
make settings.
9. Turn off the device and power sources and remove the meter.
10. Connect your coaxial cable to the LNB and turn on your set-top box again. The set
satellite should now be received with your TV.
Note:
If you use satellite systems or LNBs with special reception types (eg Unicable,
DiSEqC circuits, ...), first you must set this via the app. By default, the satellites
„Astra 1" with DiSEqC 1.0 port 1 and „Hotbird" with port 2 are occupied.
ENGLISH
07