Unicable Settings (En 50494); Unicable Settings (En 50607) - Megasat HD 1 Smart Bedienungsanleitung

4. Instructions for measuring with a mobile device

4.7.1 Unicable settings (EN 50494)

Under the „Switch" option, select SCD if you
are operating the system with a Unicable
system or LNB (EN 50494).
Then, under the Band option, select the
band you want to measure. If the correct
frequencies are not listed, you can manually
enter the frequency by tapping on the respective band.
Note:
Unicable (SCD) can be manage max. 8 frequency bands (set-top
boxes). For measurements on special unicabledockets, an additional
receiver in the Unicable network may be necessary.

4.7.2 Unicable settings (EN 50607)

Under the „Switch" option, select SCD2 if you
are operating the system with a Unicable
system or LNB (EN 50607).
Then, under the Band option, select the
band you want to measure. If the correct
frequencies are not listed, you can manually
enter the frequency by tapping on the respective band.
Note:
Unicable (SCD2) can be manage max. 32 frequency bands (set-top
boxes). For measurements on special unicabledockets, an additional
receiver in the Unicable network may be necessary.
ENGLISH
17