Maintenance; Scheduled Maintenance Table - Nilfisk Advance SR 1100S B Betriebsanleitung

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off and, if necessary, the batteries must be
disconnected.
Moreover, carefully read all the instructions in the Safety chapter before performing any maintenance procedure.

SCHEDULED MAINTENANCE TABLE

Procedure
WET battery fl uid level check
Side and main broom height check and adjustment
Dust fi lter cleaning and integrity check
Skirt height and operation check
Filter shaker operation check
Main broom driving belt visual inspection
Nut and screw tightening check
Service and parking brake check and adjustment
Steering chain check and cleaning
Main broom driving belt replacement
Main motor and drive system motor carbon brush check or
replacement
(*) For the relevant procedure, see the Service Manual.
(1) And after the fi rst 8 running-in hours.
16
USER MANUAL
146 2494 000(2)2007-02 A
Every 10
Upon delivery
hours
SR 1100S B
Every Every
Every 50
100 200
hours
hours hours
(*)
(*)
(*)(1)
(*)
(*)
(*)
Every
400
hours
(*)