HomeMatic HM-Dis-EP-WM55 Montageanleitung Und Bedienungsanleitung Seite 55

The device LED flashes green to indicate the
configuration mode.
• The push-button channels 1+2 and the status
channel 3 are taught-in at the same time.
• If teaching of the push-buttons is successful, it
is indicated with an illuminated green LED.
• If you want to exit configuration mode, press the
teach-in button again.
• After a short time, the newly taught-in device will
appear in the inbox of your software interface.
The button "Inbox (x new devices)" indicates
how many new devices have been taught-in
successfully.
• If required, you can teach-in additional devices
by repeating the steps described above for each
device.
• Now configure the newly taught-in devices in the
Start-up
55