HomeMatic HM-Dis-EP-WM55 Montageanleitung Und Bedienungsanleitung Seite 46

Start-up
• Use a pen to mark the positions of two bore
holes (diagonally opposite) in the mounting
plate on the wall.
The bore holes in the middle can be used for
installation with a flush-mounting box.
If the device is mounted to a flush-mounting
box, there may be no open wire ends.
• Now drill the bore holes.
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs
supplied. If you are working with a wooden wall,
you can pre-drill 1.5 mm holes to make screws
easier to insert.
• Use the screws and plugs supplied to fasten the
mounting plate to the wall.
46