Terminating Wake-Up And Alarm Signal, Snooze Mode - Eurochron WS1173 Bedienungsanleitung

e) Terminating Wake-Up and Alarm Signal, Snooze Mode
Stopping the Alarm Signal
When the wake-up signal is triggered at the set wake-up time, the icon "
ally to the right of the time display in the weather station display.
The wake-up signal is automatically terminated after 120 seconds. To terminate it prematurely,
briefly push one of the four buttons "SET", "ALM", "MIN/MAX" or "+" on the front of the weather
station.
The wake-up signal is triggered again at the set time on the next day until you switch off the
wake-up function.
Snooze mode for the wake-up signal
The wake-up signal can be interrupted for 5 minutes if you briefly push the button "SNOOZE/
LIGHT" on the top of the weather station. The icon "
Then the wake-up signal is started again.
The snooze mode can be started several times in sequence (max. 5 times).
Terminating alarm signal
When a set value (e.g. outdoor temperature) is exceeded or undercut, the weather station will
issue an alarm (duration approx. 120 seconds). The respective icon "HI AL" or "LO AL" will also
flash in the display area for the respective value.
To terminate the alarm signal prematurely, briefly push any button.
The corresponding icon "HI AL" or "LO AL" and "
When the measured value leaves the warning range, the icons will disappear and the
alarm is reset.
Observe that the signal sound will not be triggered again for the same alarm within the
next 10 minutes. This is to avoid continuous alarm in case of fluctuating weather.
50
" to the right of the time flashes.
" will continue to flash.
" flashes addition-