Installation; Precautions; Environment; Unpacking And Inspection - Mettler Toledo Mini-Tiger Bedienungsanleitung

METTLER TOLEDO

Installation

Precautions

This chapter gives detailed instructions and important information to install the Mini-Tiger scale successfully.

Environment

Before you install your Mini-Tiger scale, identify the best location for the equipment. The proper environment enhances the
operation and longevity of the scale. Keep in mind the following factors, which might have a negative influence on the scale's
operation:
☞Vibration
Vibration diminishes the scale's ability to measure accurately. Electrical machinery such as conveyors and drill presses can
cause inaccurate and non-repeatable readings. The scale may also read inaccurately if it is not leveled properly.
☞Air current
Moving air can cause the scale to read an additional force (add. weight) and have the same effect as vibration.
☞Friction
A scale cannot measure accurately if an object is rubbing or pressing against the platter.

Unpacking and inspection

Please inspect the package as it is delivered by the carrier. If the shipping container is damaged, check for internal damage
and file a freight claim with the carrier if necessary. If the container is undamaged, open the box, remove the scale and place
it on a solid, flat surface. Please keep the packing material and shipping insert in case you need to return the scale to METTLER
TOLEDO. The Mini-Tiger is a precision instrument and may be permanently damaged if not shipped in factory approved
packaging.
Package contents for all Mini-Tiger units include:
☞ Mini-Tiger scale

Setup

Open the box and pull up the scale, including the packing material. Remove the packing material from each side of the scale.
Set the unit on a sturdy, level surface. Level the scale by turning the adjustable feet on the bottom of the unit. When the bubble
indicator is in the centre of the circle, Mini-Tiger is levelled correctly.
Bubble indicator:
All four feet must touch the surface to make sure that Mini-Tiger does not rock.
Put the platter on top of Mini-Tiger.
Unpack the power adapter and plug it into the bottom of the scale. Plug the line cord into a properly grounded AC power outlet.

Power up sequence

Press the power key
scale performs a diagnostic test on its ROM and RAM, and proceeds to normal operating mode. The power-up sequence is
as follows:
Light all segments of the display characters. This verifies operation of all segments.
•
Display the software revision and part number.
•
Display GEO value in weight window.
•
Capture zero and be ready for normal operation.
•
Note: Before switching on the Mini-Tiger scale, always make sure there is nothing on the platter.
Mini-Tiger
☞ platter ☞ AC-DC power adapter
Good Wrong
to turn on the Mini-Tiger. The Mini-Tiger goes through a series of self-tests when it is turned on. The
☞ operation manual
GB
5