Mounting The Camera; Tools Required - Dometic Waeco PerfectView CAM60 Einbau- Und Bedienungsanleitung

PerfectView CAM60
 To prevent damage to the cables, when laying them ensure that there is
sufficient distance to hot or moving vehicle components (exhaust pipes,
drive shafts, light systems, fans, heater etc.). Use corrugated piping or
other protective materials to protect against mechanical wear.
 Screw on the plug connections of the connecting cables to protect against
water penetration (fig. g, page 6).
 When laying electric connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (fig. 3,
page 3)
 Attach the cables securely in the vehicles to prevent tripping hazards.
Use cable binders, insulating tape or glue the cables in place.
 Protect every through-hole made in the bodywork against water pene-
tration, e.g. by using a cable with a sealant and by spraying the cable and
the the cable sleeve with sealant.
NOTE
I
Do not start sealing the through-holes until all installation work has
been finished for the camera, and the required cable lengths have
been established.
8

Mounting the camera

8.1

Tools required

For installation and assembly you will require the following tools:
 Drill bit set (fig. 1 1, page 2)
 Drill (fig. 1 2, page 2)
 Screwdriver (fig. 1 3, page 2)
 Set of ring or open-ended spanners (fig. 1 4, page 2)
 Measuring ruler (fig. 1 5, page 2)
 Hammer (fig. 1 6, page 2)
 Centre punch (fig. 1 7, page 2)
EN
Mounting the camera
29