Jacuzzi J-460 Montageanweisung, Bedienung Und Wartung Seite 54

press ENT button (9) to confirm selection. Then search your
desired file as above method.
J-1000™ Audio System iPod Operation
Open front panel (16) and plug a iPod into the iPod Docking Sta-
tion (12) as shown. Refer to step 12 (page 61) for details. The
iPod will begin to play automatically.
Close front panel. The "iPod" symbol will display to indicate a iPod
is connected.
• If you want to enter iPod mode, press the MODE key (4) and
select iPod: the player will start to play the tracks on the iPod.
The display will show the title of the current track, its duration,
and the iPod symbol.
Note: DRM (Digital Right Management) files cannot be played
using this system. Personal files (MP3, WMA, iTunes, and
AAC) can be played unless they have been codified using
DRM technology.
Searching files in your iPod
To move to the next track, press the TUNE key (2) upwards
once. The track counter will increase by one track. Once you
reach the last track, it will start to play from track 1 again.
• To move quickly: press and hold the TUNE key (2) upward
until the track counter reaches the number of the track you want
and then release it.
• To scan backwards in the current track: press and hold the
TUNE key (2) downwards. The track will scan backwards until
you release the key.
Note: When you press the TUNE key once, the current track
is restarted. If you press it again you move to the previous track.
iPod Folder Search
• To select a folder: press the AS/PS key (6) to display the con-
tents and the playlists. Use the VOL key (3) to scroll through:
Playlist, Artist, Albums, Genre, Song, etc.
Then press the ENT key (9) to enter the file. Use the VOL key
(3) to make any further choices.
Note: you must press the ENT key (9) each time you want to
select a file or a folder.
Hints for Using your iPod
You can use the audio system key (7) to play/pause the iPod,
but not the random or RDM function.
Pressing the key (8), you will enter the repeat function for the
current track.
DOCKING YOUR IPOD MUSIC PLAYER
Docking Your iPod
The Docking Station for iPod is compatible with all dockable
Apple iPod models.
- Open Docking Station door (A).
- Center iPod over Docking Station Interface Port, then gently
press downward as shown (B). DO NOT FORCE!
- Close Docking Station door as shown (C), then press firmly on
door directly above door release latch (15) until you hear an
audible "click".
WARNING
• Never install or remove iPod while hands are wet or while
sitting partially immersed or fully immersed in spa!
• Never leave iPod in Docking Station when spa is not is use
to prevent damage from outdoor elements!
• Never spray Docking Station with pressurized water hose for
any reason! Damage to iPod or spa stereo system caused by
water intrusion is not covered under the manufacturer warranty!
Damage to Docking Station port or iPod due to excessive
force or improper alignment during installation or removal from
Docking Station is not covered under warranty.
Setting Up The iPod for Use
1. Select and play preferred song/album/playlist prior to docking
iPod.
2. Press "MODE" button on stereo receiver or wireless remote
until display reads "iPod. "
Note: USB Docking Station is similar to the iPod Docking
Station operation.
Use Wireless Remote to Operate iPod
- Press : Next track.
- Press & Hold : Fast forward.
- Press x 2 : Return to beginning of current track.
54